Arduino Sensor Shield V5 0 Manual «Latest ◉»

Arduino Sensor Shield V5.0 Go to product viewer dialog for this item.

void loop() int motionState = digitalRead(motionPin); if (motionState == HIGH) Serial.println("Motion Detected!"); arduino sensor shield v5 0 manual

  • Always inspect jumper positions for power selection before connecting USB power.
  • Use external regulated power for servos or loads >500 mA; tie grounds together.
  • Verify pin labels against your specific shield revision to avoid miswiring.
  • For I2C modules, ensure pull-ups are present (some shields do not add them) to avoid bus issues.
  • If stacking multiple shields, check header alignment and clearance for wires and connectors.

Safety & Reset: Features a remote reset button for easier access when the shield is stacked. Power Configuration (The SEL Jumper) Arduino Sensor Shield V5

  • D10, D11, D12, D13: Also used for SPI communication (SS, MOSI, MISO, SCK).
  • D3, D5, D6, D9, D10, D11: Highlighted for PWM (Pulse Width Modulation).
Κοινοποίηση
Αντιγραφή συνδέσμου ανάρτησης