Avery Berkel L126 Calibration Info

Report: Avery Berkel L126 Scale Calibration Procedure

Step 1: Enter Calibration Mode

  1. Turn off the scale (unplug if possible, or press the power button).
  2. Press and hold the following keys simultaneously (depending on firmware version):

    2. The Scale Reverts to Old Values After Restart

    Cause: You did not exit calibration mode properly, or there is a weak internal battery (RTC battery). Fix: Repeat the calibration, but after pressing "ENTER" or "PRICE 2", wait 10 seconds before turning off the power. If the issue persists, replace the CR2032 battery on the main PCB. avery berkel l126 calibration

    Small screwdriver or pen (to access the calibration switch). Level, stable, and vibration-free surface. 3. Pre-Calibration Requirements Report: Avery Berkel L126 Scale Calibration Procedure Step

    1. Once in Calibration Mode, the display may show CAL 0 or simply 0.
    2. Ensure the weigh platter is completely empty. Clean the platter to ensure no debris is present.
    3. Press the ZERO key (or TARE / ENTER depending on the prompt) to accept the zero point.
    4. The display will usually beep or flash, indicating the zero has been captured.
    5. The scale will now automatically prompt for Span Calibration (often showing CAL SP or the value of the test weight).
    • Tip: Use the specific weight value shown on the display. If the scale is configured for 60kg, it might ask for a 60kg weight, or a fraction thereof (e.g., 20kg).