Jungheinrich Eje 120 Error Code 4372 Work Access

Understanding and Troubleshooting Jungheinrich EJE 120 Error Code 4372

Step 5: Software Diagnosis (Dealer Level)

If the hardware checks out, connect a Jungheinrich diagnostic laptop. jungheinrich eje 120 error code 4372 work

Step-by-step troubleshooting

  1. Hardware Check: Inspect the tillerhead card and internal wiring for signs of damage, humidity, or loose connections. Hardware Check: Inspect the tillerhead card and internal

    The Conflict: The truck's computer detects that the tiller head is neither in a clear "neutral" position nor a clear "active" position for drive or lift functions. Marta finds the 3-pin connector (power

    Step 2 – The Diagnosis Path

    Marta brings her diagnostic tablet (if available) or uses the truck’s built-in service menu. She confirms:

    Can anyone shed any light please as to what could be the fault. Battery is fine and holds up well under load. Thanks in advance. . Forkliftaction Discussion: error code 4372 - Forums - Forklift Action

    Step 3 – Most Common Fixes (in order)

    A. Check the lift height sensor connection
    Under the plastic cover at the lower mast, Marta finds the 3-pin connector (power, ground, signal). One pin is corroded – green oxidation. She cleans it with contact spray and reconnects. Restart – same error.

Email Signup

Please check errors in the form above
Thank you for signing up for email updates!
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Understanding and Troubleshooting Jungheinrich EJE 120 Error Code 4372

Step 5: Software Diagnosis (Dealer Level)

If the hardware checks out, connect a Jungheinrich diagnostic laptop.

Step-by-step troubleshooting

  1. Hardware Check: Inspect the tillerhead card and internal wiring for signs of damage, humidity, or loose connections.

    The Conflict: The truck's computer detects that the tiller head is neither in a clear "neutral" position nor a clear "active" position for drive or lift functions.

    Step 2 – The Diagnosis Path

    Marta brings her diagnostic tablet (if available) or uses the truck’s built-in service menu. She confirms:

    Can anyone shed any light please as to what could be the fault. Battery is fine and holds up well under load. Thanks in advance. . Forkliftaction Discussion: error code 4372 - Forums - Forklift Action

    Step 3 – Most Common Fixes (in order)

    A. Check the lift height sensor connection
    Under the plastic cover at the lower mast, Marta finds the 3-pin connector (power, ground, signal). One pin is corroded – green oxidation. She cleans it with contact spray and reconnects. Restart – same error.