Upgrade Receiver Iclass 9696x Pvr 2013 !!hot!! | Top-Rated ◆ |
Upgrading the Iclass 9696x PVR receiver (also known under the Hivion brand) typically involves updating its firmware via a USB flash drive. While official support for 2013-era models has largely moved to community archives, the manual update process remains consistent for these devices. Upgrade Preparation Hardware Requirements : A USB flash drive formatted to Software Acquisition
You can use this for a blog post, a service guide, a user manual addendum, or a forum FAQ. Upgrade Receiver Iclass 9696x Pvr 2013
- You need 4K or HEVC.
- You dislike tinkering.
- Your tuner is failing (poor signal lock – not fixable by upgrades).
: Insert the USB drive into the front or rear USB port of the receiver. Menu Navigation : Use the remote to navigate to the Installation menu. Look for an option labeled USB Upgrade S/W Upgrade : Select the firmware file from the USB list. Upgrading the Iclass 9696x PVR receiver (also known
Troubleshooting After Upgrade
| Problem | Solution | | :--- | :--- | | "No signal" after firmware update | Re-save your satellite settings (LNB frequency may have reset to default). | | PVR recording fails | Ensure HDD is formatted to EXT3, not NTFS. | | Box freezes on startup | Perform a factory reset via the rear panel recovery switch (hold Menu while powering on). | You need 4K or HEVC
Do not power off the device or remove the USB drive while the progress bar is moving, as this can "brick" the receiver.
Procedure:
- Open the bottom panel (4 screws).
- Locate the SATA cage – remove the old drive.
- Install the new SSD/HDD.
- Power on the receiver.
- Go to Menu > USB/HDD Management > Format HDD (choose EXT3 for PVR functions).